Site Map

No obligation free estimate 416.782.1900Available 24/7

Get A Quote Now

* Required fields

Limited Time Offer

Request a FREE NO-Obligation Estimate and Receive a 10% OFF Discount Today. Call Now 416.782.1900

Top 3 Places to Use Polyurethane Spray Foam at Home

Most people don’t think about their home’s insulation until the weather turns chilly. In extreme weather, your home is affected by seasonal changes, often resulting in temperature changes inside. If your home isn’t particularly well insulated, it’s possible for air from the outside to leak in or for air from the inside to leak out. This leads to energy loss and higher heating and cooling bills. Gaps in walls, floors or ceilings can even act as an entrance for pests, leading to other problems.

 

If you’re looking for ways to improve your home’s energy efficiency, spray foam insulation is a great choice. With some careful planning, you can reduce energy usage and improve your home’s interior environment. If you’re on a budget, there are a few places you can install the foam to get the most bang for your buck. Read on for 3 areas that should be considered a top priority.

 

1.) The attic – The attic is one of the most dreaded insulation projects in most homes. Many attics lack proper insulation which leads to energy loss and high heating and cooling bills. If your attic is scorching hot in the summer and freezing in the winter, odds are you have something to worry about. It’s important to have good ventilation between the attic and the outside as well as a proper barrier between your main living space and attic air.

 

Applying a layer of spray foam insulation in the attic can help seal any cracks or gaps that are preventing you from controlling the air flow to the space. When you insulate the attic, make sure that the walls and ceiling is your target area. Once those spaces have been sealed, look around for air leaks, particularly in corners and around windows or pipes.

 

2.) The basement – The basement is an area that typically isn’t high on the list of insulating priorities. Most people look up when addressing air flow problems rather than looking underfoot. Unfortunately, mold and mildew can quickly grow if your basement isn’t properly insulated. These common contaminants can cause a variety of health problems including triggering allergies or asthma.

 

When adding spray foam insulation to the basement, focus on areas where air can leak in from the outside, causing a draft. This includes anywhere that there is an electrical wire, a pipe or a vent. Sometimes duct vent to the basement before heading outside, so look for these types of protrusions as well.

 

3.) The exterior of the building – For the best seal, look both inside and outside the home. While the attic or basement are large and obvious sources of heat loss, less obvious places exist as well. Take a walk around your home and note any faucets, like hose hookups, dryer vents, cable entrances and pipes. While these areas may seem relatively small, they still provide a significant opportunity for air to exchange and for bugs to enter your living space.

 

You will need much less spray foam insulation to cover exterior gaps, cracks and holes than for a basement or attic. You can either seal exterior leaks from the outside or inside, depending on what is the easiest for you. Simply spray the foam into the space or the gap and it will expend to fill the space. You will see results almost immediately.

 

Using spray foam insulation in your home is beneficial in a variety of ways. It reduces the cost of energy required to heat or cool the space, lowers your home’s carbon footprint and prevents unwanted pests from entering your living area. You can expect to reduce your heating bill by roughly 10 percent after insulating these 3 common areas.

 

If you would like a quote on having spray foam insulation added to your space, click on the link below.